Installation Precautions for Egg Beaters

The egg beater should be used tightly, which requires that the egg beater should be installed in a way that it is tight and cannot leak.　　First of all, the installation location of the egg beater should be in an outlet with direct access to the outdoors or passageway, and it should be ensured that the location of the equipment is well ventilated.

Secondly, when installing the cover, the sealing surfaces between the body cover should be prevented from knocking against each other. When tightening the main nut, tighten it gradually by diagonally and symmetrically in several times. The force should be even, and the cover should not be allowed to tilt to one side in order to achieve a good sealing effect. Positive and negative nut coupling, only allowed to rotate the positive and negative nut, the two arc sealing surface shall not be rotated relative to each other, all the nuts threaded couplings have assembly, should be coated with lubricating oil. Needle valve system line seal, only need to gently turn the valve needle, pressure tight sealing surface, can achieve good sealing effect.

Finally, use your hand to pan the rotary body on the machine to check whether the operation is flexible. Check whether the movable parts and fixed contacts on the panel and the back plate are normal, draw open the top cover, check whether the contact of the connectors is loose, whether there is any damage or corrosion caused by transportation and poor storage.